I decided to have a look at the Avo 7 multimeter this afternoon. The spring clip doesn't seem right as its not pulling back the cutout lever. However, until today I didn't not the damage that has been done!! I do have some questions:
- is this the cause of the cut out issues?
- is this repairable?
- what are the values of the resistors that need to be replaced?
I'm assuming that these are Welwyn type resistors but I have no idea of the values?
- is this the cause of the cut out issues?
- is this repairable?
- what are the values of the resistors that need to be replaced?
I'm assuming that these are Welwyn type resistors but I have no idea of the values?
if all else fails...read the instructions!
