04-03-2019, 05:14 PM
(This post was last modified: 04-03-2019, 05:15 PM by Jac Janssen.)
Hi Frank,
I removed the DIP-switch and transferred it to the other side of the pcb.
And I removed the AS connector from the FPGA development board (because I did not have a spare 10 pin connector...) and connected this with wires to the accessible side of the JTAG connector, as you advised me.
I made two rectangular openings in the bottom of the case and positioned the DIP-switch (fixed position because of the pcb) and the JTAG connector there.
I can now easily access both from the underside of the Hedghog, without opening the casing, see attachment.
My quantity of Hedghogs is limited
Jac
I removed the DIP-switch and transferred it to the other side of the pcb.
And I removed the AS connector from the FPGA development board (because I did not have a spare 10 pin connector...) and connected this with wires to the accessible side of the JTAG connector, as you advised me.
I made two rectangular openings in the bottom of the case and positioned the DIP-switch (fixed position because of the pcb) and the JTAG connector there.
I can now easily access both from the underside of the Hedghog, without opening the casing, see attachment.
My quantity of Hedghogs is limited
Jac
