24-02-2015, 11:58 PM
That sounds like progress 
Providing there's no audible crossover distortion, I wouldn't worry about the quiescent current being a little bit low. Sure, if it was here, I'd measure the distortion, just to be sure, but as we are very sensitive to crossover distortion, a subjective test is probably good enough.
Very wise to let it soak, just in case. But I suspect that you're right about it being "job done"...
Out of interest, what transistors did you decide to use?
All the best,
Mark
Providing there's no audible crossover distortion, I wouldn't worry about the quiescent current being a little bit low. Sure, if it was here, I'd measure the distortion, just to be sure, but as we are very sensitive to crossover distortion, a subjective test is probably good enough.
Very wise to let it soak, just in case. But I suspect that you're right about it being "job done"...
Out of interest, what transistors did you decide to use?
All the best,
Mark
