27-08-2014, 01:07 PM
Just picked up an unloved older (10+ years) Multico PM20 morticer plus a load of chisels for a bargain price, but it needs a small amount of TLC...
All the important stuff is fine and it'll clean up well, but I'm looking for a User Manual/Service Guide to check a few things - stuff like replacing the NVR switch is easy...
Also, a few knobs/levers are very tatty/missing bits - apart from Axminster (who only sell metric-shafted replacement handles etc.), where else can I get spares?
If anyone has a PDF of the manual, that would be fantastic... this machine deserves to be brought back to full health...
Was also contemplating a re-spray - Probably need to get an HVLP gun - any recommendations as to guns & materials?
All the important stuff is fine and it'll clean up well, but I'm looking for a User Manual/Service Guide to check a few things - stuff like replacing the NVR switch is easy...
Also, a few knobs/levers are very tatty/missing bits - apart from Axminster (who only sell metric-shafted replacement handles etc.), where else can I get spares?
If anyone has a PDF of the manual, that would be fantastic... this machine deserves to be brought back to full health...
Was also contemplating a re-spray - Probably need to get an HVLP gun - any recommendations as to guns & materials?
sıʌǝɹq ɐʇıʌ `ɐƃuol sɹɐ
ʞɔıu
ʞɔıu
