Telequipment V2 amplifier

[Alistair D]

After a very long wait I have finally bought a V2 dual trace amplifier to go with my small collection of TQ plugins. OK so I had to purchase a full D83 scope to go with it.

I know that the V2 has been discussed on the fora before but I am hoping that someone has found some calibration and or service data that I can get a copy of.

Al

[ppppenguin]

Have you looked here?
http://bama.edebris.com/manuals/telequipment/d83

Also don't forget that the D75 is almost identical apart from a smaller screen and different physical arrangement.

Back in the early 1980s I had a D83 on my bench at Michael Cox Electronics. Unless somebody pinched it, in which case I would end up with a D75 or a Gould/Advance OS3000. None of them bad scopes but not a patch on a decent Tek 2xxx, where that could be almost any from a 2215 to a 2465B. Of course at that time those Teks were either not invented yet or unaffordable for a small company.

[Alistair D]

Thanks Jeffrey, I've seen that manual before. I think the V2 refers to it being version 2 of the manual. Alas it does not contain any data on the V2 module.

Al

[ppppenguin]

The only dual trace plugin that seems to show up online is the V4. As in this photo: http://w140.com/tekwiki/wiki/Telequipmen...nd_s2c.jpg

What's special about the V2?

[Alistair D]

The V2 has an analogue output on one of the channels. It is ideal for attaching a frequency counter. 

The PCBs and the component references are completely different to the V4 so the V4 manual is of virtually no use when it comes to calibration.

Al