26-11-2016, 04:44 AM
A rodding eye is an unnecessary "catch" point. On 22mm bore its fairly useless anyway. A wet and dry vac will clear any unlikely blockage. In my experience the only place you can get a blockage in a proper installation is in the pump inlet, its the smallest aperture, smaller than the pipe bore.
Where your pipe exits the wall, use 2 off 45deg bends and sink one fully into the wall. If that is not possible, use a 90deg discharging downwards not horizontal followed by 2 off 45deg to get you back to near horizontal again. If you ensure a fall always so that there is complete drainage of the pipe there will be no problem, even externally in the frost. If you are using 22mm copper, there are bends rather than elbows available, or slow bend the pipe even better.
Do Marley still make adjustable solvent o/flow bends? It would appear not sadly. May be worth asking them.
Strap on 21.5mm condensate boss SWS4C will connect to a soil stack without a reducer.
Where your pipe exits the wall, use 2 off 45deg bends and sink one fully into the wall. If that is not possible, use a 90deg discharging downwards not horizontal followed by 2 off 45deg to get you back to near horizontal again. If you ensure a fall always so that there is complete drainage of the pipe there will be no problem, even externally in the frost. If you are using 22mm copper, there are bends rather than elbows available, or slow bend the pipe even better.
Do Marley still make adjustable solvent o/flow bends? It would appear not sadly. May be worth asking them.
Strap on 21.5mm condensate boss SWS4C will connect to a soil stack without a reducer.
Boater Sam.










