01-10-2023, 11:16 PM
I know this is an older thread but I happened accross it whislt doing some research. I also have one of these Davenset GC battery chargers which I too am trying to restore back to working condition - My charger is missing the rectifier valve, barretters and lamp.
I believe the main rectifier valve is a Phillips 367 or equivalent, but I am having a bit of a job trying to identify the barretters (I believe Davenset called them resistance tubes).
I did see a different charger of a similar vintage on another forum. This other charger had the same Phillips 367 valve accompanied by Phillips 1130 Barretters but these have a B4 base rather than the Edision Screw type that is on my charger.
Would anyone know which type of barretter would have been used?
Any help would be greatly appreicated.
I believe the main rectifier valve is a Phillips 367 or equivalent, but I am having a bit of a job trying to identify the barretters (I believe Davenset called them resistance tubes).
I did see a different charger of a similar vintage on another forum. This other charger had the same Phillips 367 valve accompanied by Phillips 1130 Barretters but these have a B4 base rather than the Edision Screw type that is on my charger.
Would anyone know which type of barretter would have been used?
Any help would be greatly appreicated.
