02-12-2022, 10:58 AM
(This post was last modified: 02-12-2022, 10:59 AM by Radio Fixer.)
Well Rob thanks for your thoughts. The original resistors 3 X 100K are SMD and must have very low wattage and not much voltage rating but I will check the rating of my thin film to be sure.
Yes! Trevor, thanks, I would normally remove at least one of the SMD resistors but as Mark says they are not going to cause any prob and its hard to see how they could go short as a final failure mode. But will check out getting hold of the correct value / voltage, always better to do a "proper job" (Frank Murphy).
Gary
Yes! Trevor, thanks, I would normally remove at least one of the SMD resistors but as Mark says they are not going to cause any prob and its hard to see how they could go short as a final failure mode. But will check out getting hold of the correct value / voltage, always better to do a "proper job" (Frank Murphy).
Gary
