27-08-2022, 06:16 PM
(This post was last modified: 27-08-2022, 06:17 PM by Murphyv310.)
Hi.
Best way is to short all three legs together with a suitable crock clip or whatever you have. Ideally you need it on an antistatic mat with you at the same potential, remove the short then measure between source and drain with a dmm on diode test then reverse the connections and do the same, report what you find.
Now to the very same with the other MOSFET and see if there is any difference noting what way round the dmm leads are connected
Best way is to short all three legs together with a suitable crock clip or whatever you have. Ideally you need it on an antistatic mat with you at the same potential, remove the short then measure between source and drain with a dmm on diode test then reverse the connections and do the same, report what you find.
Now to the very same with the other MOSFET and see if there is any difference noting what way round the dmm leads are connected
