30-10-2021, 08:10 PM
Hi.
The final assembly needs more screening. The matrix board isn't the best form of construction for this project. Either a dedicated PCB or copper clad laminate board and manhattan construction. The valve needs to be screened and grounded, at present moving the board around causes some bending and roll of the frame. This is due to some instability.
In fact the project was to finish the MW pantry tx on matrix board but now I'm a bit unsure. I'll transfer this over in a day or two onto manhattan type of construction unless someone could make me a one off PCB?
The final assembly needs more screening. The matrix board isn't the best form of construction for this project. Either a dedicated PCB or copper clad laminate board and manhattan construction. The valve needs to be screened and grounded, at present moving the board around causes some bending and roll of the frame. This is due to some instability.
In fact the project was to finish the MW pantry tx on matrix board but now I'm a bit unsure. I'll transfer this over in a day or two onto manhattan type of construction unless someone could make me a one off PCB?
