16-08-2021, 02:30 PM
Hi all.
Quick Q
I've a little idea I want to try involving using a P series valve.
I have a measured 13 volt AC supply available in the equipment this is to be fitted to, am I right in thinking using a diode dropper I'll get the ≈9volts (equivalent power) that the heater in the valve is rated for? (13•0.707)
Read about this recently but not sure of the conversion factor
TA!
Quick Q
I've a little idea I want to try involving using a P series valve.
I have a measured 13 volt AC supply available in the equipment this is to be fitted to, am I right in thinking using a diode dropper I'll get the ≈9volts (equivalent power) that the heater in the valve is rated for? (13•0.707)
Read about this recently but not sure of the conversion factor
TA!
