27-01-2021, 03:26 PM
(This post was last modified: 27-01-2021, 03:27 PM by Murphyv310.)
Hi.
I managed to get the picture focused on the MW6-2, I also did a video here: https://youtu.be/k3H5BiE9gPs
After the photo and video I replaced the brightness control and did a further test and soak, no issues and everything seems fine.
Managed to square up the scan coils and there is no corner cutting etc so we can see that these little tubes can really run with a totally different type of scan coils. All good fun.
I managed to get the picture focused on the MW6-2, I also did a video here: https://youtu.be/k3H5BiE9gPs
After the photo and video I replaced the brightness control and did a further test and soak, no issues and everything seems fine.
Managed to square up the scan coils and there is no corner cutting etc so we can see that these little tubes can really run with a totally different type of scan coils. All good fun.
