21-12-2020, 04:46 PM
Hi.
Yesterday I recapped the receiver along with any wildly out of spec resistors. Today I replaced any perished cables, replaced the 0.75uf hum bucking cap with 2 x 1.5uf motor run caps in series with balancing resistors added. Fitted all back and getting very good results, the CRT though needs rotating as the picture isn't level, I don't want to force the scan coils.
Just some cabinet work to do.
Yesterday I recapped the receiver along with any wildly out of spec resistors. Today I replaced any perished cables, replaced the 0.75uf hum bucking cap with 2 x 1.5uf motor run caps in series with balancing resistors added. Fitted all back and getting very good results, the CRT though needs rotating as the picture isn't level, I don't want to force the scan coils.
Just some cabinet work to do.
