Trying to make a vision IF and Detector - fun!

[AdrianPH]

OK some progress, wired up the power supply and tested it under various conditions to see how it performs.  It was from the UKVRRR forum so no proper specs.
   

I am tending to run the boards at 230 Volts DC and each board so far HT wise is taking:-

Vision IF   24.5 mA.  Timebase 26 mA.  Tuner  24.3 mA
So need to get a series resistor to drop some Volt.   The 6.3 V heaters draw is now at 3.3 Amps.

Now no laughing at this woodwork, but I need to keep things together, so tuner Vision IF and Timebase boards at least held together for now.
   

Adrian