06-09-2020, 07:57 AM
(This post was last modified: 06-09-2020, 08:14 AM by Radio Fixer.)
No ferrite in mine and no need for it. I and others have made plenty just from bare tube and they work fine. My new AMP solder tags just screw into the WellB loop holes with their wires cut off. Some almalgamating tape is wound around the tags. Perhaps yours was faulty from new and so anything you made was going to be better.
The WellB worked as good as mine on the HMV 650 using the eye tube and the ear as a guide. Both closed the eye completely on R4 as an example. I also built more than one of the "reversed engineered amp", the WellGood, using the Manhatten technique and they worked about the same as any. Some minor differences can be found on SW but not much on MW and LW.
I gave away my last WellGood else you could have a loan and try it but it may still be possible if you are interested. The person it went to still hasnt used it as far as I know.
Gary
The WellB worked as good as mine on the HMV 650 using the eye tube and the ear as a guide. Both closed the eye completely on R4 as an example. I also built more than one of the "reversed engineered amp", the WellGood, using the Manhatten technique and they worked about the same as any. Some minor differences can be found on SW but not much on MW and LW.
I gave away my last WellGood else you could have a loan and try it but it may still be possible if you are interested. The person it went to still hasnt used it as far as I know.
Gary
