27-08-2019, 02:29 PM
(27-08-2019, 08:38 AM)Nick Wrote: The decoupling capacitors need to be as close to the IC pins as is possible.
I'd bulk up the tracks with either plain solder or a bit of tinned copper wire buried in solder on the IN and OUT tracks.
Thanks Nick
I always bulk up the track on a device like this with a run of solder and could always add a copper wire to it as well.
Like this then.
Jeffrey
I want 14-15 volts out, so the 5v one is no good for me.
The current will be an average of 1.5 to 2 amps, Which my LM317's and the fake ones just cant supply without dropping the out volts.
Mike
