07-08-2019, 04:49 PM
(05-08-2019, 07:37 PM)Murphy Maniac Wrote: Depth of the brass part is 0.25" and the diameter is the same at 0.25". There are slots immediately opposite each other for the wavechange switch, one side is showing on the photo.
The centre spindle appears tyo have a rubber sleeve over it and its diameter is 0.188".
Normally, I think you'll find that the outer, with slots as you describe, is ¼" dia (0.25") but the inner shaft is only ⅛" dia. (0.125").
Can you get an accurate measurement of the metal under that sleeve? If it does turn out to be ⅛" it may make it easier to source something that will fit if you remove the sleeve. If you leave the sleeve on for now, you will still retain the option of using either size.
