05-08-2019, 07:37 PM
Thanks for the info' Mike, I'll have to get swotting and improve my computer skills and have a go.
I have photographed and measured the shafts with results as follows: Depth of the brass part is 0.25" and the diameter is the same at 0.25". There are slots immediately opposite each other for the wavechange switch, one side is showing on the photo.
The centre spindle appears tyo have a rubber sleeve over it and its diameter is 0.188".
The overall length from top of the inner shaft to the bottom of the brass collar is 0.865"
If you do happen to have something which would do the job that would be fantastic, all expenses refunded of course.
Many thanks indeed for all your help on my behalf.
I have photographed and measured the shafts with results as follows: Depth of the brass part is 0.25" and the diameter is the same at 0.25". There are slots immediately opposite each other for the wavechange switch, one side is showing on the photo.
The centre spindle appears tyo have a rubber sleeve over it and its diameter is 0.188".
The overall length from top of the inner shaft to the bottom of the brass collar is 0.865"
If you do happen to have something which would do the job that would be fantastic, all expenses refunded of course.
Many thanks indeed for all your help on my behalf.
Geoff. (BVWS and Radiophile Member) 
