03-06-2019, 01:15 PM
I find some sleeved pin plugs are not good at carrying a heavy current long term due to economies of metal in the sleeve section of the pins.
My portable welder that runs with a non blowing fuse (brass) in the plug will melt some such plugs in about 10 minutes where others are fine, but then it does draw up to 25A. Sockets of good quality stand this current in my experience.
My portable welder that runs with a non blowing fuse (brass) in the plug will melt some such plugs in about 10 minutes where others are fine, but then it does draw up to 25A. Sockets of good quality stand this current in my experience.
Boater Sam.
