15-02-2018, 11:36 PM
0.5 ohms is a bit low for an ignition coil.
I came across one on a scooter that was as low as that. A new solid state driver was fitted against my advice and it blew up.
You can test the transistor with a good diode tester if it can do two times VBE and it is unlikely to be any good.
The trigger coil can be tested with a small 2W 12 volt bulb.
Both parts would need to be replaced as a pair.
I came across one on a scooter that was as low as that. A new solid state driver was fitted against my advice and it blew up.
You can test the transistor with a good diode tester if it can do two times VBE and it is unlikely to be any good.
The trigger coil can be tested with a small 2W 12 volt bulb.
Both parts would need to be replaced as a pair.
