21-01-2018, 03:24 PM
Actually Mike it is probably better that you do not have a pre-conceived idea of what the circuit looks like. You will be less likely to make assumptions and get it wrong. From what I've seen of your previous work on here you are more than capable of the task.
Print out your layout diagram. Number the connections of every component 1,2,3,4 as required. Do the same when you draw the component on the schematic. As you mark the connections between components on the circuit put a cross through the wires on your layout diagram.
The first iteration of the schematic will look terrible as it always does but with a bit of tidying up you'll get there.
Al
Print out your layout diagram. Number the connections of every component 1,2,3,4 as required. Do the same when you draw the component on the schematic. As you mark the connections between components on the circuit put a cross through the wires on your layout diagram.
The first iteration of the schematic will look terrible as it always does but with a bit of tidying up you'll get there.
Al
Tuned for maximum smoke . 
