26-12-2017, 08:58 PM
It has been already declared too slow for making bread. A modern fan oven took care of that only a couple of months ago.
The heating element is about 500W and is in an inner chamber that could be cut down and treated with modern insulation to make a large solder pot with the motor shaft hole blanked off with off-cuts from the top of the middle chamber.. If that were done the result would fit into a much smaller cabinet leaving the large case free for another project.
I have a wax pot already based on a gold power resistor. It only needs about 15W to melt old capacitors.
The heating element is about 500W and is in an inner chamber that could be cut down and treated with modern insulation to make a large solder pot with the motor shaft hole blanked off with off-cuts from the top of the middle chamber.. If that were done the result would fit into a much smaller cabinet leaving the large case free for another project.
I have a wax pot already based on a gold power resistor. It only needs about 15W to melt old capacitors.
