10-12-2017, 10:09 PM
I have nothing specific at the moment, but have tried small items of valve, chassis based, equipment in the past. I tend to find I get on better with more modern approaches than traditional point to point wiring. It seems to get very messy even though I have been instructed in those ways. I think I have far more experience in stripboard and similar so think in terms of that. I am tending to work toward modular approaches. Using those, I find I can easier isolate problem areas. With a metal chassis it often seems like a total rebuild is needed. I can see that a combined approach is perhaps ideal, especially if I ever work on higher power valve RF equipment wherin the PA output would need good screening.
