16-11-2017, 09:13 AM
I was afraid that you would find the dreaded green spot corrosion had wrecked the winding, its all too common.
You could try passing a current through it for a while till it warms slightly but I think you will end up rewinding it completely.
11k is very high, usually I find these to be 4k to 5k only. From wire table you could find the DC resistance from your estimate of length taking the mean diameter of the winding.
You could try passing a current through it for a while till it warms slightly but I think you will end up rewinding it completely.
11k is very high, usually I find these to be 4k to 5k only. From wire table you could find the DC resistance from your estimate of length taking the mean diameter of the winding.
Boater Sam.
