04-09-2017, 09:01 AM
(This post was last modified: 04-09-2017, 09:02 AM by Murphyv310.)
Hi.
Peter & Pam dropped in yesterday along with the beautiful Jaguar SS saloon, pity though time was tight and I didn't get a run round the block, perhaps some other time. I showed Peter the sync separator and frame generator that I made to modulate the Z mode on a scope and also the TV22 running 240 lines, the flicker apparently is much worse than on the pre war HMV.
I'm going to have a go with the PC but I need to check today if my PC has the necessary slot for the graphics card. I have been offered a newer one if I get stuck.
One thing that occured to me is if using 405 and you have a dual standard colour set then you have an easy way of resolving colour at baseband as RGB is available from the graphics card, not true 405 line colour admittedly but a bit of fun.
Peter & Pam dropped in yesterday along with the beautiful Jaguar SS saloon, pity though time was tight and I didn't get a run round the block, perhaps some other time. I showed Peter the sync separator and frame generator that I made to modulate the Z mode on a scope and also the TV22 running 240 lines, the flicker apparently is much worse than on the pre war HMV.
I'm going to have a go with the PC but I need to check today if my PC has the necessary slot for the graphics card. I have been offered a newer one if I get stuck.
One thing that occured to me is if using 405 and you have a dual standard colour set then you have an easy way of resolving colour at baseband as RGB is available from the graphics card, not true 405 line colour admittedly but a bit of fun.
