24-03-2017, 08:43 PM
Hi Sam, leads are connected like some modern terminal blocks
Push button above hole, stuff lead in hole, release button. A good low resistance contact.
It should have a switch on the side that may say ohms and insulation or some such. Select desired range, connect leads and crank handle. Pointer should quickly settle at circuit reading
Simples!
Ed
Push button above hole, stuff lead in hole, release button. A good low resistance contact.
It should have a switch on the side that may say ohms and insulation or some such. Select desired range, connect leads and crank handle. Pointer should quickly settle at circuit reading
Simples!
Ed
