15-02-2017, 08:48 PM
Tried free run using Timebase cal tried every setting no joy.
The actual signal looks similar to waveform but flickering.
Tried two balance screws exercised them noted positions little better it's just two pots for calibration.
Why would altering attenuation on y1&y2 interfere with these pots?
At least I learning about this scope.
The actual signal looks similar to waveform but flickering.
Tried two balance screws exercised them noted positions little better it's just two pots for calibration.
Why would altering attenuation on y1&y2 interfere with these pots?
At least I learning about this scope.
