|
Re-labelling valves...
|
|
30-11-2016, 09:55 AM
(14-01-2016, 12:14 PM)Terry Wrote: At least with the etched batch codes that Philips used you could always go through your stock looking for a match if you didn't know what the valve came out of! The etching only refers to all glass valves - it was printed on the base in older types. If you haven't already seen it, here is a handy list for decoding Philips group codes. In the UK, of course, these will virtually all carry the Mullard name. |
| Messages In This Thread |
|
Re-labelling valves... - by Nick - 16-04-2015, 10:11 AM
RE: Re-labelling valves... - by Pat Pending - 01-01-2016, 11:07 PM
RE: Re-labelling valves... - by Ed_Dinning - 13-01-2016, 08:11 PM
RE: Re-labelling valves... - by Pat Pending - 13-01-2016, 11:02 PM
RE: Re-labelling valves... - by Terry - 14-01-2016, 12:14 PM
RE: Re-labelling valves... - by Terry - 30-11-2016, 09:55 AM
RE: Re-labelling valves... - by Ed_Dinning - 14-01-2016, 08:51 PM
RE: Re-labelling valves... - by ed731pdh - 29-11-2016, 06:23 PM
RE: Re-labelling valves... - by Pat Pending - 29-11-2016, 07:24 PM
RE: Re-labelling valves... - by Sparks - 29-11-2016, 09:10 PM
RE: Re-labelling valves... - by Refugee - 30-11-2016, 01:01 AM
RE: Re-labelling valves... - by boater sam - 30-11-2016, 02:29 AM
RE: Re-labelling valves... - by Mike Watterson - 30-11-2016, 09:28 AM
RE: Re-labelling valves... - by Valvebloke - 30-11-2016, 10:01 AM
|
| Users browsing this thread: |
| 1 Guest(s) |
