05-11-2016, 01:45 PM
OK - I've just re-read it as well, and I think it's clear that I've talking about the anode voltage, but if there's any doubt, then I'm happy to have it clarified. The object is to help understanding, after all. I've added (in red) the word "input" to one paragraph 
The one thing I'm not sure about - because of my lack of experience with valves - is just how "saturated" a valve can be. With bipolar transistors, transistors, it's pretty easy at a first and even a second look (though to do saturation properly gets surprisingly complex, but it's mercifully rare to need to go there). With MOS-FETs and JFETs it's even easier because the channel is basically resistive. But honestly, I'd be guessing when it comes to valves.
Obviously that, plus whatever is across the cathode resistor (assuming it's held still by a bypass cap) determines how low the anode can swing. So that's where "deliberate vagueness" and "carefully chosen words" came in. Any other apparently vagueness was for the sake of teaching, where knowing what to leave out and even occasional "white lies" are wholly appropriate at a given level

The one thing I'm not sure about - because of my lack of experience with valves - is just how "saturated" a valve can be. With bipolar transistors, transistors, it's pretty easy at a first and even a second look (though to do saturation properly gets surprisingly complex, but it's mercifully rare to need to go there). With MOS-FETs and JFETs it's even easier because the channel is basically resistive. But honestly, I'd be guessing when it comes to valves.
Obviously that, plus whatever is across the cathode resistor (assuming it's held still by a bypass cap) determines how low the anode can swing. So that's where "deliberate vagueness" and "carefully chosen words" came in. Any other apparently vagueness was for the sake of teaching, where knowing what to leave out and even occasional "white lies" are wholly appropriate at a given level







