28-09-2016, 07:22 PM
(This post was last modified: 28-09-2016, 07:23 PM by Murphyv310.)
By gum that looks a rough job!!!
Far too much solder on those joints. I'd say it would be an easy removal, no signs of adhesive in the chip's body.
I sincerely hope you've taken a decent deposit on the repair and charge appropriately. The demise of CHS is a reminder that we are a dead trade now and we should realise if this is our only source of income that a job like this should be worth our while.
I'm surprised that no number is printed on the top surface of the chip, I wonder if the number has been erased from the top of the component, if so again why this trade is good at knocking us for six
Far too much solder on those joints. I'd say it would be an easy removal, no signs of adhesive in the chip's body.
I sincerely hope you've taken a decent deposit on the repair and charge appropriately. The demise of CHS is a reminder that we are a dead trade now and we should realise if this is our only source of income that a job like this should be worth our while.
I'm surprised that no number is printed on the top surface of the chip, I wonder if the number has been erased from the top of the component, if so again why this trade is good at knocking us for six
