04-09-2016, 07:29 PM
(This post was last modified: 04-09-2016, 07:40 PM by AlanBeckett.
Edit Reason: Typo
)
Doesn't look too bad.
Be careful tightening down the bearings. Plain bearings need a but of running clearance, and particularly if they're worn you can crack the casting if you give it too much welly.
"Any ideas on locating a topslide and the plate it mounts to "
Errrr. I don't think there is one. It's just a T-nut, and bolt, or bit of threaded rod and a nut if that's what's handy.
Alan
Be careful tightening down the bearings. Plain bearings need a but of running clearance, and particularly if they're worn you can crack the casting if you give it too much welly.
"Any ideas on locating a topslide and the plate it mounts to "
Errrr. I don't think there is one. It's just a T-nut, and bolt, or bit of threaded rod and a nut if that's what's handy.
Alan
