28-08-2016, 04:58 PM
Hi all
On the service sheet it mentions in several places the following protection measures - add 2 x2V7 400mW Zener diodes wired back to back in series across R16. To this end I have purchased some BZX55 Zeners at 2.7V 500mW to use. I assume that this is how its connected and polarity will need to be considered. Am I correct in my thinking?
Best Regards
On the service sheet it mentions in several places the following protection measures - add 2 x2V7 400mW Zener diodes wired back to back in series across R16. To this end I have purchased some BZX55 Zeners at 2.7V 500mW to use. I assume that this is how its connected and polarity will need to be considered. Am I correct in my thinking?
Best Regards
if all else fails...read the instructions!
