13-05-2016, 02:44 PM
I had this problem after changing the belt on a trio turntable .
I found the the new belt was too tight ,this was enough to pull the motor slightly off of true.
another belt from a different supplier cured the problem
Comparing the two the 1st one was 5mm shorter than the one that worked.
Rob T
I found the the new belt was too tight ,this was enough to pull the motor slightly off of true.
another belt from a different supplier cured the problem
Comparing the two the 1st one was 5mm shorter than the one that worked.
Rob T
if its made by hand it can be repaired by hand
