Re-labelling valves...

0 Vote(s) - 0 Average
1
2
3
4
5

Re-labelling valves...

Ed_Dinning

Senior Transmitter Engineer

Posts: 573
Reputation: 3
Location: Newcastle on Tyne

13-01-2016, 08:11 PM

Hi Gents, a pad printer could be used, with suitable ink to print on the curves surface of valves.
This is basically a soft rubber pad that is inked from a stencil and then pushed onto the surface that needs to be printed.

Ed

Quote

Messages In This Thread

Re-labelling valves... - by Nick - 16-04-2015, 10:11 AM

RE: Re-labelling valves... - by Pat Pending - 01-01-2016, 11:07 PM

RE: Re-labelling valves... - by Ed_Dinning - 13-01-2016, 08:11 PM

RE: Re-labelling valves... - by Pat Pending - 13-01-2016, 11:02 PM

RE: Re-labelling valves... - by Terry - 14-01-2016, 12:14 PM

RE: Re-labelling valves... - by Terry - 30-11-2016, 09:55 AM

RE: Re-labelling valves... - by Ed_Dinning - 14-01-2016, 08:51 PM

RE: Re-labelling valves... - by ed731pdh - 29-11-2016, 06:23 PM

RE: Re-labelling valves... - by Pat Pending - 29-11-2016, 07:24 PM

RE: Re-labelling valves... - by Sparks - 29-11-2016, 09:10 PM

RE: Re-labelling valves... - by Refugee - 30-11-2016, 01:01 AM

RE: Re-labelling valves... - by boater sam - 30-11-2016, 02:29 AM

RE: Re-labelling valves... - by Mike Watterson - 30-11-2016, 09:28 AM

RE: Re-labelling valves... - by Valvebloke - 30-11-2016, 10:01 AM

Users browsing this thread:

1 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me