09-12-2015, 10:20 PM
I did make a careful note of the T/T height before removing it from the original motor, and set it the same height (18mm above the deck plate) when fitting the new motor. Admittedly the measurement was only made with a metal ruler, but AFAIK it's correct and not fouling anything. I don't have a new optical block of the correct type, so would have to obtain one. Perhaps I should check that the existing one is actually working first. To think that all this came about because I balked at paying CHS £111 for a new assembly, c/w both motors and the optical block. I did say back at post #1 that 'I should know better!'
