02-12-2015, 10:38 AM
Very much somethng to try if you're stuck for a replacement output transformer in a radio etc. Then if the sound is acceptable you're OK. For a high quality amplifier you'd need to do proper measurements, not the lash-up I'm about to suggest.
No reason in theory why you can't measure a transformer. A low amplitude frequency response test is easy. So is adding some DC. A full power test is a bit harder as you'd need a signal generator with a very high output voltage. With care you could measure in reverse, using a modern amplifier to drive the low voltage winding, loading the mains winding with Ra of your proposed output valve. Put the DC in the mains side, it'll be easier.
With a scope you'll only see gross distortion but there's always the old tricks of winding up the amplitude and/or the DC until you can see the waveform distorting.
No reason in theory why you can't measure a transformer. A low amplitude frequency response test is easy. So is adding some DC. A full power test is a bit harder as you'd need a signal generator with a very high output voltage. With care you could measure in reverse, using a modern amplifier to drive the low voltage winding, loading the mains winding with Ra of your proposed output valve. Put the DC in the mains side, it'll be easier.
With a scope you'll only see gross distortion but there's always the old tricks of winding up the amplitude and/or the DC until you can see the waveform distorting.
www.borinsky.co.uk Jeffrey Borinsky www.becg.tv







