24-05-2015, 02:33 PM
(This post was last modified: 24-05-2015, 02:53 PM by pwdrive.
Edit Reason: additional info
)
"Connect Channel 1's input to the sweep terminal on the front panel. What happens to the dot? Does it move to a new position on the screen? Or, does it change into a vertical line?"
Damn...I was about to suggest that
Sweep out to ext X in ?
Edit: Since writing the last sentence above I've just found the book of words...not a lot to be gained from that test...anyways how's about an external signal to the X in, might give some sort of indication/confirmation/idea etc.
Lawrence.
Damn...I was about to suggest that
Sweep out to ext X in ?
Edit: Since writing the last sentence above I've just found the book of words...not a lot to be gained from that test...anyways how's about an external signal to the X in, might give some sort of indication/confirmation/idea etc.
Lawrence.
