02-05-2015, 07:57 PM
Decided on 4mm ply as a filler/facia board. Fret sawed a panel with cut outs for the tuning scale and to let the sound out of the speaker. Fits beautifully, now got to find a suitable fret fabric.
The distortion on the audio was residual 50 Hz hum, a couple of hours to reform the smoothing caps has cured it.
Volume control only goes to nought after the mains switch has clicked off. I can't see an answer to this without replacing it and that seems a shame as otherwise it is fine.
I may get round to some 'photos later.
The distortion on the audio was residual 50 Hz hum, a couple of hours to reform the smoothing caps has cured it.
Volume control only goes to nought after the mains switch has clicked off. I can't see an answer to this without replacing it and that seems a shame as otherwise it is fine.
I may get round to some 'photos later.
Boater Sam.
