27-03-2015, 11:26 AM
I've just bought one of the Ready made testers off eBay ( the same one as in your posts #91 & 92, Alan. It arrived yesterday, after only 7 days in the post from Shenzen, China. I haven't tested it yet, but may well fit it into a plastic box as in your post #98. Point taken about the display, but the one on my tester is larger (ca. 58 x 38mm overall, and is set well to the left of the PCB as viewed from the front, so that it covers the top LH fixing hole, so I'll have to lift it clear in order to be able to pass a screw through the hole, or maybe fit screw with spacers through the bottom of the box, and not put a nut on the top LH one. As to the ZIF socket, I'm not sure whether to remove it or not, but will almost certainly fit three seperate terminals wired to the pads in any case. The PCB may well fit into that case sold with the self-assembly tester, but as tthe display with the latter appears to be smaller, the hole for that would need enlarging.
