01-01-2015, 10:13 PM
There are 4 tiny Mouldings on the Backlight which aligns the Display. I fancy a few dabs of Silicone Sealer will fix it properly.
I have to say that I took a few deep breaths while taking the ZIF out, but as I said, it was quite straightforward.
I fear the Box is going to be black Plastic, mainly because I have one and I don't want to stop. They do look very swish though. I really must get my finger out come the better Weather and make one of David's Comb Joint Jigs.
Unfortunately the ZIF didn't survive the trip. I took the top off in the hope of being able to lift the Pins out and it all sprang to bits
The active area of the Display is 55mm x 30mm so I need to carefully cut a hole in my Box. Of course if it doesn't go well ......
Alan
I have to say that I took a few deep breaths while taking the ZIF out, but as I said, it was quite straightforward.
I fear the Box is going to be black Plastic, mainly because I have one and I don't want to stop. They do look very swish though. I really must get my finger out come the better Weather and make one of David's Comb Joint Jigs.
Unfortunately the ZIF didn't survive the trip. I took the top off in the hope of being able to lift the Pins out and it all sprang to bits
The active area of the Display is 55mm x 30mm so I need to carefully cut a hole in my Box. Of course if it doesn't go well ......
Alan
