13-04-2014, 06:17 PM
Collected the new one yesterday - http://www.screwfix.com/p/impax-zbw60a-2...tid=184043
It works fine and makes lots of noise.
The Glass - Plastic actually - on the Tank Gauge was cracked but I'm not short of a Gauge or two.
So, having checked it over it's now plugged into the Distribution.
Note the Toetector Sandals
I need a Right Angle to get the Gauge vertical where it will be less vulnerable. Now I know to look for Iron, even if it's Brass, it shouldn't be too difficult to get one.
I'll still get a Belt for the old one 'cause a Backup is no disadvantage.
Alan
It works fine and makes lots of noise.
The Glass - Plastic actually - on the Tank Gauge was cracked but I'm not short of a Gauge or two.
So, having checked it over it's now plugged into the Distribution.
Note the Toetector Sandals
I need a Right Angle to get the Gauge vertical where it will be less vulnerable. Now I know to look for Iron, even if it's Brass, it shouldn't be too difficult to get one.
I'll still get a Belt for the old one 'cause a Backup is no disadvantage.
Alan
