26-03-2014, 05:47 PM
Yep - this is my problem - I only have a 1/2" router table, not a spindle moulder.
That cutter would have to be about 5" in diameter - spindle + 2 x comb depth, which for 2" rail & stile would be about 5" total - couldn't do that very easily on a router table...
I'm now wondering if I could use my Leigh dovetail jig with a straight cutter, i.e. a finger joint....
That cutter would have to be about 5" in diameter - spindle + 2 x comb depth, which for 2" rail & stile would be about 5" total - couldn't do that very easily on a router table...
I'm now wondering if I could use my Leigh dovetail jig with a straight cutter, i.e. a finger joint....
sıʌǝɹq ɐʇıʌ `ɐƃuol sɹɐ
ʞɔıu
ʞɔıu
