13-03-2014, 12:12 PM
(This post was last modified: 13-03-2014, 07:43 PM by AlanBeckett.)
How thick are the Belts Col? I've found the usual Balata Belts rather thick for use on short lengths. The original short endless Belt from the Motor Pulley to the Countershaft on the big Denbigh Drill is quite thin.
The Chipmaster has a simple Dog Clutch at the Gearbox end of the Leadscrew 'cause you're not supposed to use it for anything except Threading.
It also has a couple of Shear Pins in case you get it wrong. Perhaps yours has.
Alan
The Chipmaster has a simple Dog Clutch at the Gearbox end of the Leadscrew 'cause you're not supposed to use it for anything except Threading.
It also has a couple of Shear Pins in case you get it wrong. Perhaps yours has.
Alan
