06-02-2014, 01:49 PM
I went to the market and the guy with two tables was not there and the guy with the new stuff only had 14TPI in the inch size. So it was a no show.
The G-clamp was for an 8mm tap so it was a tough one. For smaller taps I do have a holder.
I once did 100 small holes with a reversible mains power tool and got away without snapping the tap by working with a very steady hand.
I have found that warn lathes have to be learned on a scrap part before you get serious.
The G-clamp was for an 8mm tap so it was a tough one. For smaller taps I do have a holder.
I once did 100 small holes with a reversible mains power tool and got away without snapping the tap by working with a very steady hand.
I have found that warn lathes have to be learned on a scrap part before you get serious.
