19-01-2014, 04:27 PM
Hi All, here's my ML7, Nothing special, It,s an old one, 1956 I think, Myford spotters will have spotted the older type tailstock. Note the ABB inverter and Italian motor. Huge improvement on the single phase type. The wee box under the lathe controls speed, and reverse. I only use reverse for removing chucks so its limited to very low speed, programmed in the ABB. Been discussed here before but the ABB is easy to remote, the programming is a bit daunting but the book is very complete. So I,ve got a very untidy workshop/Garage, radio work is done in an upstairs room and that's just as untidy!
Peter
