My woodturning efforts

[Yorkie]

Here are a few more pics, which might make the construction and use of my comb-joint jig a little clearer (or not!). The pics show:

1) Final cut of the first piece.
2) First cut of the second piece.
3) Underside of sledge showing the 'guide peg' over which each new groove is place so that the next groove is cut accurately
4) Rear of 'sledge'.
5) The end result with the two pieces properly lined up and fitted together.

(This was only two bits of scrap wood - not an actual case being made).

Hope that's of interest.

David