22-12-2013, 03:41 PM
Hi All,
I'm back working on this set again after a long absence. At the moment, the heater chain is intact as it lights up and I can see that all of the valves are working. However, I have no signal (still) all I can hear is a slight hum (increases and decreases with volume) and a small click as I switch between mw and vhf (aerials connected of course).
Its time to use the signal injector but with my limited knowledge this one has me stumped.
Regards
Rob
I'm back working on this set again after a long absence. At the moment, the heater chain is intact as it lights up and I can see that all of the valves are working. However, I have no signal (still) all I can hear is a slight hum (increases and decreases with volume) and a small click as I switch between mw and vhf (aerials connected of course).
Its time to use the signal injector but with my limited knowledge this one has me stumped.
Regards
Rob
if all else fails...read the instructions!
