15-12-2013, 06:07 PM
Can the chuck jaws on the small lathe be turned over so that it can hold a slice of large bar?
If it could hold a piece big enough you could turn up a part that same diameter as the flange on the broken casting.
I understand that this would have to be done with many small cuts on a small machine but the part would be fine in the end.
I am sure you must also have a tool that can do the inside diameter of the bearing carrier.
If it could hold a piece big enough you could turn up a part that same diameter as the flange on the broken casting.
I understand that this would have to be done with many small cuts on a small machine but the part would be fine in the end.
I am sure you must also have a tool that can do the inside diameter of the bearing carrier.
