14-12-2013, 04:43 PM
It sounds as though the wave change switch might need a good clean or a wire is loose.
By the way if the original detector diode has gone low reverse resistance then bridging it might not make much difference depending on how bad it is.
The switches can be deceptive, you think they may be clean but they are not, it only takes a thin layer of dirt or oxidization to increase the resistance of the contacts.
Lawrence.
By the way if the original detector diode has gone low reverse resistance then bridging it might not make much difference depending on how bad it is.
The switches can be deceptive, you think they may be clean but they are not, it only takes a thin layer of dirt or oxidization to increase the resistance of the contacts.
Lawrence.
