07-10-2013, 12:58 PM
The improvement I made was to link the non plated hole printed circuit that relied on the terminal posts to make the connection so that if they come loose again it will not blow the transistor again.
It was a very fiddly job and the wires had to be traced through the center tap generator printed circuit before it got to the loose terminal. It produces a center tapped output for running op amp supplies as well as normal bench service.
It has been fine since the repair.
It was a very fiddly job and the wires had to be traced through the center tap generator printed circuit before it got to the loose terminal. It produces a center tapped output for running op amp supplies as well as normal bench service.
It has been fine since the repair.
